4” X 48” Phillips / Technidrill BTA Ejector Type Deep Hole Drilling Machine

Manufacturer

PHILLIPS

Category

Drilling Machines

Type

DRILLS, DEEP HOLE

Stock

HSD1170

Model

BTA

Dealer Location

Illinois

Request a Quote
View Contact Information

Spec Sheet

Drilling Diameter, Maximum - 4”
Drilling Depth, Maximum - 48”
Feed Rate - .5 to 12 IPM
Swing Over Ways - 20”
Swing Over Work Surface - 32”
Spindle Speeds - Variable (Parker DC VS Drive)
Spindle Horsepower - 40 HP
High Pressure Coolant Pump - 15 HP
Electrics - 3/60/480V
Approx. Drill Dimensions - 188” x 48” x 72” Height
Approx. Coolant System Dimensions - 128” x 64” x 96” Height


EQUIPPED WITH:
Operators Control Station with Spindle Pressure / Drill Monitor Load Meter. Spindle RPM Display. Spindle Variable Speed Controller. Feed IPM Thumb Wheel Selector. Manual and Automatic Operation Controls. Manual Operation Controls for Spindle Run. Coolant. Rapid Advance. Forward Feed, Retract, E-Stop, and Emergency Retract. Updated with Parker DC Spindle Speed Drive.

High-Pressure Coolant Filtration System with 7.5 HP Filter Pump that Removes Coolant from the bottom of the Settling Tank and Pumps it Through Filters into the Clean Coolant Top Tank. Micron Polishing Filtration with (2) Cartridge Type Filters. 15 HP Grundfos High-Pressure Coolant Pump. Chip Conveyor. Air-Oil Mist Lubrication to the Spindle. Automatic Way Lubrication System. Transformer. 

32” x 72” T-Slotted Work Surface. Tailstock with Spring Loaded Cup Type Support. (3) Pressure Heads. Large Assortment of Spring Collets for Pressure Heads. (2) Drill Bush Heads with Large Assortment of Sleeves, Bushings, and Lock Nuts. Large Assortment of BTA Tubes (Some Extend for up to 96” Drilling). Large Assortment of BTA Drill Heads. 

No Video Available

Want to request a quote from the owner of this listing?

Request a Quote